小型壓路機在使用時該注意些什么呢？今天路工集團小編就位大家好好講解下：

一、變速箱保養

變速箱每季至少清洗一次，清洗時，首先在熱狀態下，停車擰開變速箱側端的放油螺塞，把箱內潤滑油放岀，再把油塞擰上，箱內灌入煤油，起動柴油機，使變速箱低速運轉2-3分鐘，停車放掉煤油，清洗油塞并擰到變速箱上，（注意必須將煤油清放干浄，以免潤滑油與殘留煤油混合而失去潤滑效果），然后再加新潤滑油，加至油面到油尺的標志線。

變速箱用20號齒輪油必須經常檢査和調整變速操縱機構和換向機構的定位裝置，使齒輪保持在適當的位置，以免引起脫檔事故。

要經常注意檢査變速箱各密封處的滲漏情況，如果密封件損壞要及時更換。

要經常檢査變速箱與機架聯接螺栓，必要時擰緊，勿使松動脫落。

二、液壓系統保養

檢査濾清器、閥、馬達、油泵、油缸等的安裝螺栓是否松動，各接頭處是否漏油。

觀察油箱側而的油位計，當液壓油過少時應添加同樣牌號經過過濾后的液壓油液壓汕箱半年清洗一次并換油，添加或換油時，千萬注意不要將雜質污物混入油箱，添加或換的新油必須事先經過濾清。

液壓油用68號抗磨液壓油液壓油濾清器每使用500小時后要進行清洗或更換濾清器濾芯。

三、振動輪保養

振動輪每1000小時更換一次潤滑油。隨時檢査振動輪潤滑油是否有漏損；檢査油位時應將加油口轉至正上方，打開放油口，使油漏出到不漏或少漏為止

保養時更換振動輪潤滑油，換油時應注意清潔潤滑油用CD級30號柴機油行走軸承的潤滑保養，應在整機使用平均20天后，在相應的油杯位置加注足量的鈣基質潤滑脂。

四、主離合器保養主離合器除隨時注意調整其操縱機構外，還應注意檢查和調整其3只分離桿的末端位于同一平面內，并使其與分離軸承保持一定的間隙（0.4~0.7毫米）。

主離合器接合和脫開時均應平穩緩和，不得用力過猛，離合器接合時必須使離合器踏板冋到原來位置，使離合器完全接合，離合器在脫開時，必須將踏板踏到底，使離合器完仝脫開，在操縱時，必須防止使離合器處于半離合半接合狀態，以免將離合器燒壞。

經常檢査主離合器，避免摩擦片和壓板的表面沾染油污。

五、側傳動保養側傳動由于轉速低，負荷大，又易受灰塵泥砂的沾染，應經常注意檢査其潤滑情況，定期將齒輪上的泥、砂、細石屑污垢清除，并涂上一層新的鈣基潤滑脂，以免發生損壞事故。

六、蓄電池保養蓄電池使用日久，如因使用不當和維護不當時，常見電液比重低落，充電時電壓特高，放電時電壓特低等現象，且在極板外發現有白色結晶顆粒，形成電池的“酸鹽”，致使其不能應用，被酸鹽化的電池，輕者可用較小電流經過1-2次充電后即可恢復正常用酸比重計檢査電池組的荷電情況，看是否電池充分荷電，電解液的比重在充分荷電時應為1.28（15oC），如比重降到1.2，就應當借別的電源給電池組充電。

在正常的條件下，柴油機的發電機就足以使電瓶充滿電，但在冬天時，電瓶組應注意經常保持充滿狀態，以免凍結為避免蓄電池電極硬化，產生硫酸垢，蓄電池處于放電狀態時間不得超過24小時，充好后若暫不使用亦應于每周內進行充電一次，至電池內充分發出氣泡為蓄電池表面必須經常保持清潔，若有灰塵或電解液流出時，最好用氯化銨酒精或10%硫酸銨液浸濕的抹布擦凈。

如果您在后續使用路工壓路機過程中，有任何問題可以隨時咨詢我們的在線客服或者撥打全國客服電話400-0123-003，我們將竭誠為大家服務，路工集團專業生產小型壓路機12年，選擇路工、選擇放心！